Carpet cleaning machine Faucet direct connection conversion kit.
Do you own a Cross American Jaguar 6.6 or similar machine with the lift out solution suction hose?
Convert the machine to pressure feed instead of suction feed and improve the pump performance another 75 psi and make the water up to 15 degrees hotter at the same time.

Here is how it is laid out.

1.  The part on the left is a 140 degree pump sensor.  If the water is over 140 degree it sprays water into the the sink.  The sensor self closes and constantly monitors the hottest water allowed for your pump head.  Equipped with a 1/4" barbed fitting to add a hose of your choice.
http://www.steam-brite.com/adams-thermal-relief-valve-female-brass-with-viton-oring-degrees-p-11924.html 

2.  Center top is a female garden hose swivel on a 90 degree turn.  The 90 turn allows for use in shorter sinks.  An optional Auto fill hose can also be connected here.
Visit http://www.steam-brite.com/shazaam-auto-fill-hose-inch-with-degree-fitting-water-garden-hose-p-7553.html as an example.

3.  Lower center piece is a 1/4" barbed fitting.  This is only because Cross American uses 1/4" lift out hose.  You might use different hose on your machine.  If you need these barbed fitting to be 3/8" barbed, please state that too.

4.  Right side of photo.  Flow through 1/4" QD with 1/4" barbed fitting.  This is from the return from the pressure regulator.  The QD allow you to disconnect and fill jugs and sprayers.  If your machine has a heater safety pressure return, you will have to request for an additional tee fitting be installed to accommodated that hose at an extra fee.

What if you do not own a machine with a lift out hose?  You say "my machine only has an acorn strainer on the bottom of the fresh water tank."  It does not matter.  You order the same part with hoses that hook to the fitting that are at the bottom of you fresh tank.  We will not guess on this for you.  You have to tell us the plumbing number of the fitting.  What we mean is you cannot call us and say "I own a bla bla bla brand machine, what hoses do I need?"  We are not going to answer this.  Please figure this out on your own.  Most manufacture change connection on the bottom of their machine all the time., so we are not going to guess for you.  No consistency here.  If you want 3/8" Fip or 1/4" Fip or what ever the connection is, you have to tell us.  If you do not know, you will have to go to your local hardware store and purchase a 1/4" fitting, and a 3/8" fitting and a 1/2" fitting and see what fits.  Once you know what you needed you can email us the configuration.  The photo above is only an example of what can be done.