FOSTER 40-20 ANTIMICROBIAL COATING
This EPA registered fungicidal coating prevents the re-growth and spread of molds and odor causing bacteria on walls, ceilings, pipes and HVAC duct systems. (Color is white.) MATERIAL SAFETY DATA SHEET __________________________________________________________________________________________ REVISION DATE: 11-16-2010 SUPERSEDES: 05-07-2010 SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION COMPANY INFORMATION H.B. Fuller Construction Products Inc. (formerly Specialty Construction Brands, Inc. An H.B. Fuller Company) 1105 S. Frontenac Street Aurora, IL 60504 Phone: 1-800-323-7407 Medical Emergency Phone Number (24 Hours): 1-888-853-1758 Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300 PRODUCT INFORMATION PRODUCT NUMBER: FOSTER 40-20 PRODUCT DESCRIPTION: Coating PRODUCT IDENTIFIER: 827566PM SECTION 2: HAZARDS IDENTIFICATION EMERGENCY OVERVIEW PHYSICAL STATE: Liquid COLOR: White ODOR: Mild Sweet POTENTIAL HEALTH EFFECTS BY ROUTE OF ENTRY EYE: Can cause minor irritation, tearing and reddening. SKIN: Can cause minor skin irritation, defatting, and dermatitis. INHALATION: Can cause minor respiratory irritation. Inhalation of dusts produced during cutting, grinding or sanding of this product may cause irritation of the respiratory tract. Overexposure to barium dust/fume may cause baritosis. This product contains one or more materials that may be hazardous when present as an airborne dust. During normal handling of the product, the material is encapsulated within the product and will not present an exposure risk. Once the product has reached its final state and is abraded or disturbed, dusting and exposure may occur. INGESTION: Ingestion is not an anticipated route of exposure. No hazard in normal industrial use. LONG-TERM (CHRONIC) HEALTH EFFECTS TARGET ORGAN(S): Lungs REGULATED CARCINOGEN STATUS: Unless noted below, this product does not contain regulated levels of NTP, IARC, ACGIH, or OSHA listed carcinogens. Titanium dioxide EXISTING HEALTH CONDITIONS AFFECTED BY EXPOSURE: Lung disease SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS Chemical Name CAS # PERCENT Aluminum hydroxide 21645-51-2 10 - 30 Barium compound 13701-59-2 5 - 10 Calcium carbonate 471-34-1 5 - 10 827566PM Page 2 of 5 11-30-2010 MATERIAL SAFETY DATA SHEET __________________________________________________________________________________________ Titanium dioxide 13463-67-7 5 - 10 Zinc oxide 1314-13-2 1 - 5 Mineral oil 64742-46-7 0.1 - 1 Unlisted ingredients are not 'hazardous' per the Occupational Safety and Health Administration Hazard Communication Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous Materials Information System ingredient disclosure list. See Section 8 for exposure limit guidelines. SECTION 4: FIRST AID MEASURES IF IN EYES: Use an eye wash to remove a chemical from your eye regardless of the level of hazard. Flush the affected eye for at least twenty minutes. Tilt the head to prevent chemical from transferring to the uncontaminated eye. Seek medical advice after flushing. IF ON SKIN: Wash with soap and water. Get medical attention if irritation develops or persists. IF VAPORS INHALED: Remove to fresh air. Call a physician if symptoms persist. IF SWALLOWED: Do not induce vomiting. Seek medical attention if symptoms develop. Provide medical care provider with this MSDS. Induced vomiting may lead to aspiration of the material into the lungs potentially causing chemical pneumonitis that may be fatal. SECTION 5: FIRE FIGHTING MEASURES FLASH POINT: Non flammable AUTOIGNITION TEMPERATURE: Not established LOWER EXPLOSIVE LIMIT (% in air): Not established UPPER EXPLOSIVE LIMIT (% in air): Not established EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide. UNUSUAL FIRE AND EXPLOSION HAZARDS: There is a possibility of pressure buildup in closed containers when heated. Water spray may be used to cool the containers. SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear selfcontained breathing apparatus and full protective equipment. HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide Metal fumes SECTION 6: ACCIDENTAL RELEASE MEASURES SPECIAL PROTECTION: No adverse health effects expected from the clean-up of spilled material. Follow personal protective equipment recommendations found in Section 8 of this MSDS. CLEAN-UP: Dike if necessary, contain spill with inert absorbent and transfer to containers for disposal. Keep spilled product out of sewers, watersheds, or water systems. Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300 SECTION 7: HANDLING AND STORAGE Handling: No special handling instructions due to toxicity. Storage: Store in a cool, dry place. Consult the Technical Data Sheet for specific storage instructions. SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION EYE PROTECTION: Wear safety glasses when handling this product. SKIN PROTECTION: Avoid skin contact by wearing chemically resistant gloves. GLOVES: Not normally required. Use nitrile gloves if conditions warrant. RESPIRATORY PROTECTION: Respiratory protection may be required to avoid overexposure when handling this product. Use a respirator if general room ventilation is 827566PM Page 3 of 5 11-30-2010 MATERIAL SAFETY DATA SHEET __________________________________________________________________________________________ not available or sufficient to eliminate symptoms. Respirators should be selected by and used following requirements found in OSHA's respirator standard (29 CFR 1910.134). VENTILATION: Use local exhaust ventilation or other engineering controls to minimize exposures. EXPOSURE LIMITS: Chemical Name ACGIH EXPOSURE LIMITS OSHA PEL Aluminum hydroxide Not established Not established Barium compound Not established Not established Calcium carbonate Not established 15 mg/m3 TWA (total dust); 5 mg/m3 TWA (respirable fraction) Titanium dioxide 10 mg/m3 TWA 15 mg/m3 TWA total dust Zinc oxide 2 mg/m3 TWA respirable fraction 10 mg/m3 STEL respirable fraction 5 mg/m3 TWA fume; 15 mg/m3 TWA total dust; 5 mg/m3 TWA respirable fraction Mineral oil Not established 5 mg/m3 TWA (as mist) SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES PHYSICAL STATE: Liquid COLOR: White ODOR: Mild Sweet ODOR THRESHOLD: Not established WEIGHT PER GALLON (lbs.): 11.9 SPECIFIC GRAVITY: 1.43 SOLIDS (% by weight): 67.4 pH: Not established FLASH POINT: Non flammable BOILING POINT (deg. C): Not established FREEZING/MELTING POINT (deg. C): Not established VAPOR PRESSURE (mm Hg): Not established VAPOR DENSITY: Not established EVAPORATION RATE: Not established OCTANOL/WATER COEFFICIENT: Not established VOC, weight percent 2.19 VOC, EPA Method 24 (theoretically determined) 31.4g/liter of material VOC, EPA Method 24, less water and exempt solvents (theoretically determined) 35.3g/liter of material 827566PM Page 4 of 5 11-30-2010 MATERIAL SAFETY DATA SHEET __________________________________________________________________________________________ VOC, EPA Method 24 (analytically determined) 41.94g/liter of material SECTION 10: STABILITY AND REACTIVITY STABILITY: Stable under normal conditions. CHEMICAL INCOMPATIBILITY: Not established HAZARDOUS POLYMERIZATION: Will not occur. HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide Metal fumes SECTION 11: TOXICOLOGICAL INFORMATION COMPONENT LD50/LC50 Aluminum hydroxide Not established Barium compound Not established Calcium carbonate Oral LD50 Rat = 6450 mg/kg Titanium dioxide Not established Zinc oxide Oral LD50 Mouse > 950 mg/kg Inhalation LC50 Mouse = 2500 mg/cu m (no duration specified) Mineral oil Not established TOXICOLOGY SUMMARY: No additional health information available. SECTION 12: ECOLOGICAL INFORMATION OVERVIEW: No ecological information available SECTION 13: DISPOSAL CONSIDERATIONS To the best of our knowledge, this product does not meet the definition of hazardous waste under the U.S. EPA Hazardous Waste Regulations 40 CFR 261. Solidify and dispose of in an approved landfill. Consult state, local or provincial authorities for more restrictive requirements. SECTION 14: TRANSPORTATION INFORMATION Consult Bill of Lading for transportation information. DOT: NOT REGULATED IATA: NOT REGULATED SECTION 15: REGULATORY INFORMATION INVENTORY STATUS U.S. EPA TSCA: This product is in compliance with the Toxic Substances Control Act's Inventory requirements. CANADIAN CEPA DSL: This product contains a component that is not on the DSL. If you are the importer of this product into Canada, contact H.B. Fuller for chemical tracking and notification information. EUROPEAN EINECS: As a result of the introduction of REACH into Europe, this product cannot be imported into Europe unless the REACH requirements are met. If you need more information about the inventory status of this product call 651-236-5858. This product may contain chemical substances that are regulated for export by various government agencies (such as the Environmental Protection Agency, the Bureau of Industry and Security, or the Drug Enforcement 827566PM Page 5 of 5 11-30-2010 This MSDS is not prepared for distribution in California.
