Odorcide 210 Fresh Scent Concentrate


Odorcide works by permanently neutralizing malodors and replacing them with a mild, pleasant scent through a counteraction, absorption and bonding process that reactivates after initial application to continue combating malodors.

Proven and cost effective in eliminating malodors due to urine, feces, hormonal (tomcat) spray, decaying organic matter, emesis, mold & mildew. Odorcide removes embedded odors from fabrics, upholstery, carpeting, floors and walls. The concentrate can also be used to remove bad odors in toilet holding tanks, laundry soak or rinse and as a surface spray.

100% Biodegradable. Non-irritating to skin. Not corrosive to treated articles including upholstery. Water-based.

Commercial, Hospitality, Institutional or Residential Applications including:

• General Cleaning
• Pet Odors
• Flood Remediation
• Smoke Odors
• General Janitorial
• Crime Scene Cleanup
• Medical Facilities
• Laundry Applications
• Sports Applications

Directions for Use:

Dilution Ratios & Method of Application:

• Carpet - 1 oz per pint (16oz) of water - Soak or Inject
• Hard Surfaces - 1 oz per pint (16oz) of water – Spray
• General Cleaning or Rinse Water – 1 oz per two gallons (256oz) of water or 1 oz per one gallon (128oz) of water.
• Ongoing/ Preventative - ¼ oz per 16oz of water - Spray
    Laundry - ½ oz per standard laundry load; add to laundry detergent or fabric softener
• Pre-Laundry Soak - 1oz per gallon of water - Soak

Pour diluted mixture into squeeze bottle, sprayer or appropriate container for intended use. Apply enough Odorcide to saturate through to the source of the odor.

For carpet odors:
If recent, blot or remove surface matter causing the odor as much as possible. Spray or squeeze Odorcide 210 onto area to be cleaned. For deeply embedded odors, saturate area thoroughly. For carpets, stepping on the soaked area will improve penetration. Product must come in contact with the odor source to be effective. Let air dry. If odor remains, not enough product was used. Repeat.
For stains:
Rub area thoroughly with a sponge or cloth saturated with Odorcide 210. Blot with clean cloth. Let dry and vacuum.
For Air Deodorizing:
After general cleaning, spray area. Allow to air dry. Will not leave residue.

Odorcide is fully compatible with detergents, germicides and works at any temperature.

Caution:

• Effectiveness decreased when using with Chlorine solutions.
• Always spot test for color fastness.

Treating Urine Stains: Noting the surface stain is generally sufficient however, a black light or a probe that detects urine salts can be useful if urine odors are being treated. Use the rule of thumb that urine migrates laterally about 50% beyond the stain area, as well as penetrating deeply, often through backing, padding and into the sub floor.
Apply sufficient mix to cover contaminated area and to penetrate as deeply as the odorous material. PRESSURE SPRAY at 40 to 100 PSI, INJECT or POUR on. To assure penetration, use a roller or simply walk the product in. Vacuuming and cleaning can take place immediately after application. If any odor remains, it’s because ODORCIDE 210 has not penetrated to the source of the odor. Fold back the carpet and apply to the underside, padding and flooring.

Residual Action of ODORCIDE 210 reactivates deodorizing properties when the treated surface gets wet so it is usually unnecessary to use the product with every cleaning.

Penetration to Odor Source: Make certain that the Odorcide comes in physical contact with the most deeply embedded odor source to successfully remove malodors.

CC-0210FF-01

Thornell Corporation MSDS
Material Safety Data Sheet
Manufacturer: Thornell Corporation, P.O. Box 363, 100 James Street, Smithville, MO 64089 Emergency Phone: 816-873-3342
SECTION I - IDENTIFICATION
Product Name(s): Odorcide 210 Concentrate Fresh Scent
SECTION II - HAZARDOUS INGREDIENTS
Conforms to the RIFM and IFRA guidelines. Not a primary skin irritant, nor toxic by oral ingestion or by inhalation. A minor irritant when in direct contact with the eyes. Contains Isopropyl Alcohol - CAS #67-63-0, less than 0.2%
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling Point: N/A Specific Gravity (H20=1): Odorcide 210 Concentrate Fresh Scent: @25°C .915-.920
Vapor Pressure (mm Hg): N/A Melting Point: N/A Vapor Density (AIR=1): N/A Evaporation Rate (BuAC=1): N/A Solubility In Water: Completely Soluble
Appearance and Odor: Odorcide 210 Concentrate Fresh Scent: Clear to light yellow
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): Odorcide 210 Concentrate Fresh Scent: 117°F TCC
Extinguishing Media: Carbon Dioxide or other oil combatant types Special Fire Fighting Procedures: As above Unusual Fire and Explosion Hazards: None
SECTION V - REACTIVITY DATA
Stability: Stable
Conditions to Avoid: Concentrate exposure to heat and open flame. Hazardous Polymerization: Will not occur
SECTION VI - HEALTH HAZARD DATA
Health Hazards (Acute and Chronic): No acute and/or chronic health hazards. No significant adverse reactions have been reported. Liquid in eyes may cause limited, temporary irritation.
1
Thornell Corporation MSDS
2
Carcinogenicity: None Signs and Symptoms of Exposure: Minor irritation to eyes, nose and throat. Medical Conditions Generally Aggravated by Exposure: None Emergency and First Aid Procedures: If inhaled remove to fresh air. If eye contact, flush with water. Skin contact, wash with soap and water. If ingested give copious amounts of water. Contact a physician if irritation persists.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be Taken In Case Material is Released or Spilled: Use floor dessicant. Waste Disposal Method: Per local statute for combustibles. Precautions to be Taken in Handling and Storing: Avoid open flame. Other Precautions: None
SECTION VIII - CONTROL MEASURES
Respiratory Protection: Not usually required. Ventilation: Local exhaust - Not required; Mechanical (General) - Fan or blowers when required. Protective Gloves: None Eye Protection: None Other Protective Clothing or Equipment: None
SECTION IX – NFPA 704
Ready to Use Products Concentrated Products

Thornell Corporation MSDS
Material Safety Data Sheet
Manufacturer: Thornell Corporation, P.O. Box 363, 100 James Street, Smithville, MO 64089 Emergency Phone: 816-873-3342
SECTION I - IDENTIFICATION
Product Name(s): Odorcide 210 Concentrate Fresh Scent
SECTION II - HAZARDOUS INGREDIENTS
Conforms to the RIFM and IFRA guidelines. Not a primary skin irritant, nor toxic by oral ingestion or by inhalation. A minor irritant when in direct contact with the eyes. Contains Isopropyl Alcohol - CAS #67-63-0, less than 0.2%
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling Point: N/A Specific Gravity (H20=1): Odorcide 210 Concentrate Fresh Scent: @25°C .915-.920
Vapor Pressure (mm Hg): N/A Melting Point: N/A Vapor Density (AIR=1): N/A Evaporation Rate (BuAC=1): N/A Solubility In Water: Completely Soluble
Appearance and Odor: Odorcide 210 Concentrate Fresh Scent: Clear to light yellow
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): Odorcide 210 Concentrate Fresh Scent: 117°F TCC
Extinguishing Media: Carbon Dioxide or other oil combatant types Special Fire Fighting Procedures: As above Unusual Fire and Explosion Hazards: None
SECTION V - REACTIVITY DATA
Stability: Stable
Conditions to Avoid: Concentrate exposure to heat and open flame. Hazardous Polymerization: Will not occur
SECTION VI - HEALTH HAZARD DATA
Health Hazards (Acute and Chronic): No acute and/or chronic health hazards. No significant adverse reactions have been reported. Liquid in eyes may cause limited, temporary irritation.
1
Thornell Corporation MSDS
2
Carcinogenicity: None Signs and Symptoms of Exposure: Minor irritation to eyes, nose and throat. Medical Conditions Generally Aggravated by Exposure: None Emergency and First Aid Procedures: If inhaled remove to fresh air. If eye contact, flush with water. Skin contact, wash with soap and water. If ingested give copious amounts of water. Contact a physician if irritation persists.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be Taken In Case Material is Released or Spilled: Use floor dessicant. Waste Disposal Method: Per local statute for combustibles. Precautions to be Taken in Handling and Storing: Avoid open flame. Other Precautions: None
SECTION VIII - CONTROL MEASURES
Respiratory Protection: Not usually required. Ventilation: Local exhaust - Not required; Mechanical (General) - Fan or blowers when required. Protective Gloves: None Eye Protection: None Other Protective Clothing or Equipment: None
SECTION IX – NFPA 704
Ready to Use Products Concentrated Products
 





030120129994CEL